Holding times are the length of time a sample can be stored after collection and prior to analysis without significantly affecting the analytical results.
It is the minimum time period for which the synchronous inputs must remain stable in the desired logic state after active clock transition to respond reliably.
it is the time intraval required for the control levels to remain on the inputs of a flip-flop after the triggering edge of the clock in order to reliably activate the device
the hold time is the minimum time for which the control signals need to be maintained constant at the input terminals of the flip flops after the arrival of the triggerring edge of the clock pulse.
the time interval required fot the control levels to remain on the inputs to a flipflop after the triggering edge of the clock in order to reliablt activate the device.
Holding times are the length of time a sample can be stored after collection and prior to analysis without significantly affecting the analytical results.
ReplyDeleteHolding time is the time gap or the duration between needed for analysing the given sample.During this period the given sample is stored in it.
ReplyDeleteit is the time for which a value is stored till it's call..
ReplyDeleteIt is the minimum time period for which the synchronous inputs must remain stable in the desired logic state after active clock transition to respond reliably.
ReplyDeleteit is the time intraval required for the control levels to remain on the inputs of a flip-flop after the triggering edge of the clock in order to reliably activate the device
ReplyDelete•Period for which the temperature of all points within the sterilizer is held within the sterilization temperature band.
ReplyDeleteIt is basically the time for which the value is stored and used or called again for its usage.
ReplyDeleteHolding time is the total time a circuit is on use in a cal,including the operator's and user's time.
ReplyDeletethe hold time is the minimum time for which the control signals need to be maintained constant at the input terminals of the flip flops after the arrival of the triggerring edge of the clock pulse.
ReplyDeleteHolding time is the time period for which the input stays in the circuit prior to its output.....
ReplyDeleteholding time is the time in which the input stays til it gives the output.
ReplyDeleteHolding time is basically the time for which the value is stored and used in calcutating time period of user and operator....
ReplyDeleteholding time is the time period foe which the value of the input is stored until the output comes
ReplyDeleteIT IS a time in which value is stored till its call.
ReplyDeletethe time interval required fot the control levels to remain on the inputs to a flipflop after the triggering edge of the clock in order to reliablt activate the device.
ReplyDeleteit is thelength of time, a sample can be stored after collection and prior to analysis without significantly affecting the analytical results
ReplyDelete